![]() Truth is, I'm probably going to get one next month. The guns have a lifetime warranty and the factory is allegedly good about backing that up. Too, the guns are very sensitive to limp wristing. Have to polish the gun up a bit, especially one this inexpensive, does not bother me much. While this sounds a bit, er, off, there are a lot of folks who drop a bunch of money on thier chosen sidearms and then proceed, for better or worse, to 'customize' it. There is a whole internet tutorial on a Fluff & Buff process.īasically polishing the feed ramp and otherwise knocking off some sharp edges left by the factory. Every now and then, one slips out that the factory can't get to run even after three and four trips back The way they get them out the door at such a low cost is by applying minimal fit & finish to them. Some of these pistols have some serious problems. A bit o' surfing reveals these pistols have a strong following. ![]() Very slim.88', 8 rounds of 9mm, and out the door for $300. Lo and behold, there sits a PF-9 in the case. Then this week I stopped in to a gun shop that I don't get to very often. But I found myself seriously looking at the M&P Compact. I've always said that it's just as much hassle to carry a small pistol as it is to carry larger one. Kel-Tec Extended Magazine Base Pad +1 Kel-Tec P3AT. Shop a full line of Kel-Tec products at MidwayUSA. Search titles only Posted by Member: Separate names with a comma. Kel tec p32 serial number, kel tec p3at serial number year. I'm currently running a full-size.40 M&P.
0 Comments
Leave a Reply. |